Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2022 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

There are some parts which seem unobtainable are there any suggestions for this one? 1800

Graham;

To secure hardware, "drilling and safety-wiring" is always an alternative which can be used on just about any fastener...I do that now after witnessing the self-loosening of a Camnut shortly after first-start...I don't EVER want to hear those noises on a first-start again!

For the screen, as Greg notes...a simple fine screen, of brass or copper, can be made to the required size, then soldered to hold its shape...I have done this successfully also to make a prescreen for fuel...

If you give the size required, I can supply you with some of the superfine ⏜ wires per inch] solderable copper screen material (this is typically used as a pre-screen, for example as in the 1800ES tanks...any particles small enough to get through will be caught by an even finer paper post-filter)...otherwise if you contact me directly per e-mail with some more precise dimensions, I could make up what you need...

Cheers and Merry Christmas!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New There are some parts which seem unobtainable are there any suggestions for this one? [1800]
posted by  jgcoutts  on Thu Dec 23 22:42 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.