Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2020 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

There are some parts which seem unobtainable are there any suggestions for this one? 1800

What size is the brass mesh piece ?

If they are disks I have a hole punch for sheet metal (think a super duty paper punch) that will holes / disks to 9/32" diameter. Any sheet metal shop (HVAC) should have something like that.

TWP Inc will sell you a 3" X 3" sample of fine mesh screen for $10. They have ... 40, 50, 60, 80 and 100 mesh available.
https://www.twpinc.com/wire-mesh-material/brass

If you only need a small piece of brass mesh ( I have not counted the wires per inch), the sediment bowl gasket for a Ford 8N tractor comes with a piece of brass mesh for $3.
https://www.yesterdaystractors.com/Ford-8N_Fuel-Sediment-Screen-and-Gasket_2NAA916061.html

Greg






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New There are some parts which seem unobtainable are there any suggestions for this one? [1800]
posted by  jgcoutts  on Thu Dec 23 22:42 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.