Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Temperature Comp Board bypass: Questions for the post-party 200 1993

posted by  mr.zorak on  Thu Jan 18 03:27 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jul 3 10:08 CST 2014
[RELATED]

After getting tired of beating the crap out of the plastic on my son's 240 to get the temp gauge to work (which it does, but only after 3-4 hard bangs on the plastic window), I am going to bypass it using the IPD instructions w/ some wire and solder. My questions are:
#1 What size wire do i need to use to solder?
#2 What do I need to look out for regarding the rise and fall of my temp gauge? ( will it read about the same, fluctuations, etc.)

Again all input appreciated!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Temperature Comp Board bypass: Questions for the post-party [200][1993]
posted by  mr.zorak subscriber  on Thu Jan 18 03:27 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.