Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to disassemble driveshaft on 1984 245? 200 1984

posted by  mario on  Tue Oct 9 06:34 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Sep 26 09:26 CST 2014
[RELATED]

Both posts are correct, but I will add this:

Use Volvo parts (bearing and bushing)

I just had to replace both pieces (SCANTECH) in less than 2 years and under 10k miles. The bushing was separated in two places. Also the Scantech bushing is as hard as a hockey puck and impossible to but back on over the bearing. The Volvo unit is soft and flexible and went on with ease. Also the Volvo bearing is made by SKF and looked very durable. The cost is higher but it is worth it in the long run.

Mario
--
82 242 DL-MPG






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to disassemble driveshaft on 1984 245? [200][1984]
posted by  Mike_84_245  on Tue Oct 9 02:47 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.