Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Stripped Thermostat Housing Screw 200 1989

posted by  DevoFan on  Sun Jun 22 16:41 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 22 16:24 CST 2008
[RELATED]

Dear Volvo Colleagues,

well I thought I was going to partake in a simple maintenance routine of replacing a thermostat on my 1989 240 DL Wagon. I removed the 1st 10mm screw with no problem. Now the 2nd - the nightmare begins. It would not budge. I sprayed it with WD-40, and other solutions, including Coca-Cola, to try to break the seal. Eventually, I ended up stripping the screw. I tried using vice-grips; each attempt removing more and more material, so much so that the screw no longer resembles a hexagon ---- Crap!

My questions to you:

(1) What is the best method of removing it now? Should it be grinded? Drilled?
(2) What if the bolt threads also get stripped in my haste to remove the screw?

I would appreciate your comments and suggestions.

Thank you in advance.

DevoFan





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Stripped Thermostat Housing Screw [200][1989]
posted by  DevoFan  on Sun Jun 22 16:41 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.