Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pressing tie rod end out of steering arm 200 1983

posted by  Paul Driver of Inga on  Wed Jun 25 11:49 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 25 16:42 CST 2012
[RELATED]

Narrow Pickle Fork AKA Ball Joint spliter works. But leave a couple of threads on the nut and be gentle. When it drops loosen the nut and ease it out.

Unless you plan to replace the tie rod ends, then hit it like you mean it.

You can also use a smaller wheel puller, clamp the puller arms to the bottom side of the bracket and tighten down on the center nut. That will push it right out, and we don't need no stinking Special Volvo tools.

Regards,

Paul





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Pressing tie rod end out of steering arm [200][1983]
posted by  berlis  on Wed Jun 25 11:17 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.