Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pressing tie rod end out of steering arm 200 1983

posted by  David Samuels on  Wed Jun 25 16:34 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 20 12:23 CST 2014
[RELATED]

Can't remember how many times I said "next time I'll buy one", then didn't have it when I needed it. I got it at Auto Zone for less than 20 bucks. It's a C-stlye splitter with two jaws that slip under the bottom of the steering arm and a crank down "point" with hex head (and ratchet recess) to set against the top of the bolt on the tie rod end. Used mine today in fact. Ten seconds and the tie rod end popped right out. No banging, no solvents, no mess. They carry two styles, a larger one for pitman arms and one for "smaller" links. Part number 25297 by OEM, it fits the knuckle perfectly.

DS






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Pressing tie rod end out of steering arm [200][1983]
posted by  berlis  on Wed Jun 25 11:17 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.