Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2001 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

FYI on Ignition switch replacement 900

posted by  lightbulbguy on  Fri Oct 3 07:30 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Aug 16 15:17 CST 2012
[RELATED]

I just replaced my ignition switch on my 1996, 960 and it was a little different than the FAQ section. My screws were T-20 torx and the 4 screws in the corners of the bottom cover were recessed pretty far up in the cover, so my socket wouldn't reach all the way up there. i needed a torx screw driver. Secondly the tilt wheel lever had to come off. It's held on by a 3mm hex head set screw. Once i figured that out everything went according to the write up in the FAQ. Only took about 20 minutes.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

FYI on Ignition switch replacement 900

posted by  Steve on  Sun Oct 5 01:07 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 07:16 CST 2014
[RELATED]

Neil, thanks. I made the changes to the FAQ (next edition due in about two months).
Steve
--
See the 700/900 FAQ at the select shortcut button on the top right of the screen.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.