Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

How can I verify power to the ICU 200 1993

It's a wagon. I could not hear the pumps kicking on before I changed the CPS, I do now. I can also now smell gas in the engine compartment, whereas, I couldn't before. When I hook a spark tester in line with the coil to distributor wire, I get no evidence of spark coming from the coil. When I hold the wire near a ground, I get the same "no spark" condition. Fuse 4 had no power before, and now has power. I will connect the original driver's side leads to the new leads coming from the passengers side and see if the "no flash" condition changes. I must have an early 93 because I see nothing on either battery terminal, just a terminal clamp. I do appreciate you taking the time to help me out. It's nice to know that there are still good people out there.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Oh no! Not another NO START thread! [200][1993]
posted by  johnboy740  on Thu Feb 19 14:52 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.