Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2020 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

rain drip moulding 200

posted by  rstarkie on  Mon Mar 16 14:30 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

If I remember correctly you start at one end and pull the bottom edge out which allows clearance to lift/pry the top edge off.

The curve in the trim creates a problem and it becomes deformed. I used a mallet to put it back in place.

I learned this during a repaint project. I would not remove it if I were to do a total repaint again. It makes more sense to simply tape it off.

Randy
Photobucket






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rain drip moulding [200]
posted by  Nel621 subscriber  on Mon Mar 16 14:06 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.