Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2021 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

LH 2.4 ECU check O2 sensor 200

posted by  J.R. on  Fri Apr 10 09:54 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 1 20:22 CST 2011
[RELATED]

Bentley's, editor close out 07/93 version sez:

With the ECU connector off and opened for probing.

Page 241-15
Oxygen sensor wiring harness. 24 and ground

- Oxygen sensor connected = Continuity

- Separate connector and connect green wire to ground (by this I presumed it meant to go under the hood and disconnect the sensor wire from the green wire) = No continuity

When I tested, I got no continuity for the first test and continuity for the second test. I checked the errata and didn't see anything on this. I think the instruction results are reversed.

I also checked the green wire from the engine compartment to the ECU for continuity and for a short to ground and found neither. If the Bentley test is correct, any thoughts on what I've got going on?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New LH 2.4 ECU check O2 sensor [200]
posted by  J.R.  on Fri Apr 10 09:54 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.