Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Shims for Rear Wheel Bearing Race? 200 1988

posted by  TONY H on  Fri Jun 12 02:30 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

You're saying that the Press fit does not exist anymore?
How loose is loose?
What I have seen done on front Hubs, same scenario, is to take a steel chisel and bang some dents around the axle on the Race seating surface. It creates high spots on the surface and the Race will fit tight again.
Although it works, I'm not in love with this method, just reporting what I have seen done.
--
'75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.no.net/ebrox/Tony's%20cars.htm






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Shims for Rear Wheel Bearing Race? [200][1988]
posted by  Stormie  on Thu Jun 11 18:59 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.