Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Getting nuts off Exhaust manifold studs-any advice ? 200 1982

Adding a little vibration (as in tapping with a dull chisel and hammer) on the studs or nuts can be helpful in breaking the bond of rust. Anyplace that opens up a little will increase the penetration of the PB Blaster.

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Getting nuts off Exhaust manifold studs-any advice ? [200][1982]
posted by  nabramson subscriber  on Fri Sep 18 06:22 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.