Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Must I disconnect the lines at the rear calipers when changing pads and rotors? 200 1993

uid 779's pic
posted by  matt b on  Sat May 1 04:55 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 14 16:33 CST 2014
[RELATED]

the problem is there are no flexible lines leading directly to the rear calipers, so.. you'll have to bend the stiff steel lines.

Which, if I were you, I would do if possible..

To be honest though, unless your rear rotors are visibly scoured, or obviously warped, I would not replace them at all. Rears are responsible for a small percentage of your braking... the rotors don't usually go bad.

I'd just stick new pads in, and not risk doing more damage than good.
--
-Matt I ♥ my ♂






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Must I disconnect the lines at the rear calipers when changing pads and rotors? [200][1993]
posted by  cgreene  on Sat May 1 04:25 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.