Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

TAB reinstall - how to align arm and axle for bolt? 200 1989

posted by  pageda on  Sat Aug 21 03:40 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

Something about the axle is not lined up correctly, it could be up or down, left or right or the rotation front to back of the differential. You are just just going to have to play with it until it all falls in place.

Try getting the axle parallel to the ground then eyeball which way it is off and adjust from there. A large screw driver is a good tool to adjust the alignment, if it is close tap on it some with a hammer.
Dan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 TAB reinstall - how to align arm and axle for bolt? [200][1989]
posted by  dinomartino subscriber  on Sat Aug 21 03:04 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.