Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Correct driveshaft alignment information!! 200

posted by  planetman on  Fri Dec 17 17:12 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 09:29 CST 2014
[RELATED]

Hello,

I have misspoken(written) on the driveshaft alignment issue and I need to clarify!

I was correct when I said that Volvo did NOT mark their driveshafts from the factory.

And that you can visually assemble the driveshaft correctly 2 ways.

So you have a 50/50 chance of getting it right if the 2 piece driveshaft is separated without being marked!

But I was WRONG about how to correctly assemble the driveshaft!!

I hope the following will straighten things out!!

The proper way to align the driveshaft halves visually is to imagine that the splined male half of the rear driveshaft is part of the front half with the u-joint flanges parallel.

The does make the 2 welded flanges of the rear driveshaft half to be perpendicular to the 1 welded flange on the front side of the front driveshaft half.

I AM EXTREMELY SORRY FOR ANY CONFUSION I MAY HAVE CAUSED!!
--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft yoke phase/ alignment - in plane or? [200]
posted by  jon_h  on Fri Dec 17 13:33 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.