Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ANSWER removing auto shift knob and PRNDL housing 200 1990

posted by  Stickbuilder on  Thu Feb 24 10:10 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 03:31 CST 2014
[RELATED]

Its not difficult. Pry out the overdrive button, and disconnect it from the 2 wires. Place a towel over the knob. Use a large adjustable wrench, and close it until it just fits around the shifter lever under the knob. Use a large hammer and strike the wrench underneath, driving the knob off. The reason for the towel is to contain the spring and push knob which would fly around the interior. Replacing the knob is easy. Just line up the parts, and push it back on. Be sure to route the wiring for the overdrive button first.

This post has been marked as an answer to the original question.

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED removing auto shift knob and PRNDL housing [200][1990]
posted by  panelmon  on Thu Feb 24 08:32 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.