Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

oxygen sensor install 91 240 wagon 200

posted by  1990Volvo240 on  Tue Mar 8 14:57 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 3 13:18 CST 2014
[RELATED]

Hi

Open the hood and at the passenger side corner, back of the firewall disconnect the two connectors (a two prong connector and a spade connector if memory serves correct) and drop them down between the header pipe and engine. There should be a plastic clip or two under the car that holds the wire harness from the sensor itself, routing it up toward where you have unplugged the connectors. With a light under there and the hood up it should be easy to see the routing. Then go easy on unscrewing it from the cat. converter.

Travis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New oxygen sensor install 91 240 wagon [200]
posted by  DEVO! subscriber  on Tue Mar 8 14:10 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.