Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ANSWER How to tighten ball joint that has nylock nut and no flats on shaft? 200 1979

uid 27's pic
posted by  Art Benstein on  Wed Mar 23 07:25 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Not sure what works for mechanics, but I wash the conical surfaces with solvent. Since I've had air tools, the challenge is all but gone.

Edit: Another thought if you don't have air -- Clean the mating surfaces (remember how hard it was to separate them?) and use a non-locking nut to cinch them up first. Maybe then you can turn on the lock nut without the shaft spinning in the housing.
--
Art Benstein near Baltimore

My goal in life is to be as good of a person my dog already thinks I am.

This post has been marked as an answer to the original question.

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED How to tighten ball joint that has nylock nut and no flats on shaft? [200][1979]
posted by  sutherml  on Wed Mar 23 07:18 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.