Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

driveshaft 'clocking' 200 1989

posted by  Volvo From Heck on  Thu Dec 1 12:49 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 20:56 CST 2014
[RELATED]

My way of explaining the clocking of the driveshafts---the very first yoke (attached to the transmission) should be at 90 degrees from the very last yoke (attached to the diff) so that they would form one complete u-joint if joined together. Of course that leaves two possible solutions so if there are no marks it would necessary to try one and then the other if the first try didn't work out. It is my understanding that this method should work no matter how many driveshaft sections there are (many trucks have three sections). -- Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New driveshaft 'clocking' [200][1989]
posted by  anthony2  on Thu Dec 1 01:37 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.