Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1989 240 Bucking/Hesitating Then No Start 2-1-4 Code 200

posted by  kittysgreyvolvo on  Tue Jul 31 18:23 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 18 15:23 CST 2014
[RELATED]

http://www.brickboard.com/FAQ/700-900/EngineOBDCodes.htm#LH24FuelInjectionFault

http://www.brickboard.com/FAQ/700-900/EngineOBDCodes.htm

Socket Six: EZK Ignition system OBD socket code 2-1-4
RPM sensor signal absent intermittently
Faulty RPM sensor, wiring or incorrect installation

Secure your OHM / continuity meter to the two of three pins specific to the crank position sensor and wiggle the wire. The Ohms / continuity may vary.

The third pin is a ground bare ground wire. Inspection may reveal the outer sheath insulation may have failed. Rear valve cover seal (half moon shaped seal) and a missing dual clip securing that wire to the (I believe) oil dip stick tube allows the wire to wiggle during operation redicing servive life and hastening failure.

FCP Groton sells these. Made by Bougicord; the Volvo OEM providor.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED 1989 240 Bucking/Hesitating Then No Start 2-1-4 Code [200]
posted by  cgilmore  on Tue Jul 31 18:02 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.