Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

EZK Ignition Module 900 1994

posted by  HillBilly on  Mon Dec 16 08:57 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 16 08:26 CST 2014
[RELATED]

Remove the knee bolster over the drivers knees.
There are (3) Torx Screws on the front edge and (2) trim clips on the rear edge.
I't pretty easy to get off and to replace.

There is a guide pin on the bolster that slides into a hole in the dash, so you have to pull it straight out after removing the screws and trim clips.
That guide pin makes it a whole lot easier to re-install because it aligns all of the screw holes back up.

The Ignition Module is just to the right of the steering column inside the dash. (looking towards front of the car.).
It has a black plastic housing and the wiring harness plugs in from the bottom.

Hope this helps
steve





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New EZK Ignition Module [900][1994]
posted by  Townshend Act subscriber  on Sun Dec 15 20:46 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.