Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Exhaust assembly advice needed 200 1993

posted by  james_a_sousa on  Sat Apr 1 21:36 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 18:51 CST 2014
[RELATED]

Just about anything you use to try to seal that joint will be burned out.

Get a new donut - or go to an old school foreign auto parts dealer - mine had a board covered withn old school donuts made of various materials, some softer than the Volvo part.

The band clamp looks pretty good.

You might get a tailpipe cutter - mine has 4 cutting wheels and a screwdriver handle - you only have to move it a bit over 90 degrees to cut a pipe - makes a nice clean cut.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Exhaust assembly advice needed [200][1993]
posted by  woodshavings  on Sat Apr 1 13:21 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.