Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

90 240 Crank Position Sensor - OBD Not flashing 200

posted by  malloy1 on  Sun Jun 28 09:59 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 17:44 CST 2014
[RELATED]

Somebody mentioned that the OBD will not give codes if the fuel injector fuse near the battery is not powered (blown or corroded).

I checked it out. Yup-Pulled the fuse and was the same symptom:

-No fuel pump relay activating
-No spark
-OBD LED lights up when test button is pushed, but no code flashing in either the #2 or #6 pin.

I did clean the fuse and sprayed the holder and fuse with deoxit when I was cleaning the OBD box. I forgot to mention that. The car didn't run after I cleaned the OBD box and fuse holder. The fuse and holder was corroded. I'll replace the fuse and holder too.

Paul






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 90 240 Crank Position Sensor - OBD Not flashing [200]
posted by  malloy1  on Sat Jun 27 10:57 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.