Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2023 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B230FT wont start- part 2 900

Hi All,

Today the car just cranked and cranked with no start.
I had a post about this a few months ago and it's been starting
immediately like clockwork since.

This time I remembered to check OBD codes first
and found on Port-2: 1-2-1 MAF (AMM) signal missing or faulty
I unhooked the battery for 10 seconds and reconnected.
ECU reset
And zing the car started, and I wasn't late for my appointment.

I had paid close attention to the AMM connector and switched from
dielectric silicone to Penetrox there, and all seemed stable.
The AMM connector pins looked good to the evil eye.
Then I had to remove the air box to replace the washer pump and had the
AMM connector apart again.

Is this a connector problem or a funky ECU?

Something forces the ECU to fail, maybe a funky connector
Maybe old and tired out of limit caps in the ECU?
But rebooting the ECU resets back to happy motoring,
at least for a while.

Keep a 10MM swivel head gear wrench around for good luck.

Go figure, Bill








THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B230FT wont start- part 2 [900]
posted by  B.B. subscriber  on Tue Dec 12 15:34 CST 2023 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.