Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

B230FT wont start- part 2 900

fyi-no hall effect sensor is ever grounded to the engine or elsewhere. the foil coax wrap on 3 is the ground to the ecm. i've found that when that shield is broken, it causes problems. BUT, i've always seen the outer jacket cracked or broken, causing damage to the shield. i've also had non-oe sensors cause problems out of the box, so it's oe or bougicord only, no other brand.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B230FT wont start- part 2 [900]
posted by  B.B. subscriber  on Tue Dec 12 15:34 CST 2023 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.