Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Quality for replacement parts??? 200 1983

Hello All:
My son is about to return back to me, our 83 245 to use up in the Northeast for summer driving. However, it needs the strut mounts/bearings that are on top of the strut tower. should I get the cheap ScanTech replacements or bite the bullet and go for the OEM's?
thanks for your help.
Genaro.








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Quality for replacement parts??? 200 1983

I recently replaced four strut mounts on two cars ('86 & '84 -- same part) using Scan Tech.

With installation I succeeded in knocking loose at least one of the three top bolts from the bearing while trying to force the strut unit under the strut tower. The last 1/2" was too tight, so, I dislodged one bolt on each assembly.

What fun!

Anyhow. after about four months now, I have no problems with the Scan Tech units.








  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Quality for replacement parts??? 200 1983

Buy Volvo OEM or Boge. The rest is junk. Not all parts are like this where you really should buy the Volvo part, but the strut mounts definitely lack quality in the aftermarket.
--
Volvo 240 Links







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.