Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

aw-70 extension housing bushing 200 1990

posted by  someone claiming to be Heather and Erik on  Fri Dec 12 15:36 CST 2003 [RELATED]

I'm in the process of putting a junkyard tranny into my wife's 90 240 wagon. The old one died for some reason. I replaced the input and output seal and the extension housing bushing. I was not very impressed by the fit between the output flange and the bushing - over .030" slop. Anybody have experience with this. I discussed this with several of my mechanic buddies and we decided to just leave it. I had visions of making a new one but I just don't have the time now. Anyway, I bolted it all up and it definitely has less slack than before.

I would love to hear from somebody who has an opinion on this sloppy fit?

Thanks Erik








  REPLY TO THIS MESSAGE    PRINT   SAVE 

aw-70 extension housing bushing 200 1990

posted by  someone claiming to be b21ft on  Sat Dec 13 04:39 CST 2003 [RELATED]

When you get the new bushing from the tranny shop specify that is for the
AW Volvo not AW Toyota transmission.Although the trannies are similar the tail shaft bushing for AW Toyota is a bit ( a hair ) larger in it's inner diameter although it would work fine if installed in a AW Volvo trans.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.