Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2008 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1987 740 BRAKE DISK IDENTIFICATION WITH OR WITHOUT HUB 700

uid 55's pic
posted by  john sargent on  Sun Mar 14 02:07 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

It is quite likely that you have the separate hub and rotor with 10.25" diameter rotors. If you have integral hubs and rotors I recommend buying used hubs (without integral rotor), and new rotors. It is easy to upgrade from 10.25" diameter rotors to 11.25" rotors buy just buying used caliper holding brackets. Bendix and Girling use different caliper holding brackets. See the 700/900 FAQ for more information.

The front wheel bearings are the same for both integral hub and rotor and two piece hub and rotor. If you needed to buy used hubs, they would come with bearings. Just clean and grease the bearings before installing the used hubs.

If you need a set of used front hubs, let me know. I may still have a set stored in the garage.
--
john






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1987 740 BRAKE DISK IDENTIFICATION WITH OR WITHOUT HUB [700]
posted by  someone claiming to be J  on Sat Mar 13 11:44 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.