Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Flame trap on DOHC engine? 900

re: 91 940GLE (4cyl with DOHC)

There is a cylindrical canister which resembles a small oil filter, roughly 2 to 3" diameter, above the starter motor.

A widget which probably houses the flame trap attaches to the top of the cylinder.

The widget and the canister separated. The widget has a flared plastic end which can fit over the nipple at the top of the canister. I pushed the widget back onto the canister nipple.

I have no documentation on these items. Is the canister a filter which should be cleaned or replaced? Is there supposed to be a clamp which holds the widget onto the canister nipple?

Thanks,
- CarlD trimagna at yahoo dot com








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Flame trap on DOHC engine? 900

Without looking at mine, there is usually no clamp.
The canister is simply a baffle, a connection point.
Check that the flame trap is clean and open, it may be blowing itself off.
--
744-16v-4+OD 185kmi., 745-16v-4+OD 359kmi., 242Turbo-4+OD 170kmi?, 245DLT automatic 287kmi.. 245SE automatic 198Kmi.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.