Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 tank pump / sender access plate 200 1990

posted by  darmstrong on  Sat Sep 24 13:42 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 13 12:21 CST 2014
[RELATED]

I replaced the tank pump on this car long ago, and finally went back to clean up the mess. Problem is, I have two 1" diameter grommets that fit the hole in the access plate:

1) a slit grommet which I can put around the 3-wire harness from the fuel sender
2) a non-slit grommet which has a grey sheath running through it. This gray sheath carries a green-white and black wire (I believe it's from the speedometer sensor), and it runs through the hole in the access plate.

I think that when I took this apart, the sender harness was just pinched under the access plate and caulked, with only the gray sheath running through the hole in the access plate. Do they normally all run through the access plate hole? I'd like to put it back how it's supposed to be, but I'm still wondering why there are two grommets.
--
David Armstrong - '86 240(350k km?), '93 940T(270k km), '89 240(parts source for others) near Toronto







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.