Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Knock sensor + timing question 700 1989

posted by  Andrew in AL on  Thu Oct 20 15:00 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

Had some work done, replaced distributor. Tech then set the timing dead on (his words). Idle is a now bit high & I have some valve clatter under load.

Read the FAQ's on the knock sensor, and I am going to replace that. I was wondering if after I replace the sensor - should I get him to recheck the timing & is dead on the best place to set the timing on the B230FT? The reason I ask is I had thought I read that a slightly retarded timing would give a bit more power - less chance of valve clatter.

Thanks
Andrew in AL
--
'Be blessed in your quest'' 89 764 (110K), '94 940T (180K)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Knock sensor + timing question [700][1989]
posted by  Andrew in AL subscriber  on Thu Oct 20 15:00 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.