Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

WARNING notice in Bentley manual 200 1986

posted by  drboyle on  Mon Mar 6 19:02 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 29 21:31 CST 2014
[RELATED]

After troube-shooting a no-start condition,I referenced the Bentley manual and on pages 280-4 and24-8 it gives the following WARNING "do not dis-connect the harness connector from the control unit, the control unit uses special one-way guide sleeves that are damaged when dis-connected. If harness connector is removed or the control unit is replaced,the wiring harness will need to be replaced" Has anyone removed this connector and what were the consequenses? The connector to my control unit was loose so before I pushed connector back in I pulled it off to have a look.Engine started and runs fine, I don't no if this was the cause of the no-start condition or just a coincidence that the engine started. Would like to hear some thoughts on the WARNING in the Bentley






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New WARNING notice in Bentley manual [200][1986]
posted by  drboyle  on Mon Mar 6 19:02 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.