Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Exhaust Leak 200 1986

posted by  wavelore on  Sun Apr 30 04:14 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi All,

I'm new to the board and have a question about a 1986 244DL I just purchased. I've searched the FAQ's and couldn't find the info. The car developed a very loud and apparent exhaust leak at the exhaust flange between the manifold and the header pipe. I took the pipe down to replace the gasket to find it caked with some sort of bondo/sealent on both sides of the joint.

I cleaned both surfaces well and replaced the gasket. I still have a minor leak that is quite annoying, but nothing compared to the way it was before. My question is, is there a possibility of doubling up the gaskets if either surface is warped, or is there any other fix or recommendation for this issue.

Any feedback would be great, and thanks for taking the time to read this.

Wave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Exhaust Leak [200][1986]
posted by  wavelore  on Sun Apr 30 04:14 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.