Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Finishing Head Gasket work FINALLY! One last question.......91 240 200 1991

posted by  DHartlein on  Sat Nov 11 05:29 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 2 20:00 CST 2014
[RELATED]

First, thanks to everyone for helping me through my first head gasket job - this forum is a lifesaver. I just put almost everything back together - timing belt is next.

Paranoia is back. Is there ANYTHING else I need to do before turning the key on this thing after it is done? This is the first time I pulled the head and had it machined. Reinstalled it as it was when I picked it up at the shop. Should I have lubed anything? I reinstalled the camshaft sprocket and moved it slightly to align the dot with the timing mark - it was off just a bit - and the camshaft seemed kind of stiff......

I am using Bentley and Haynes, but you guys are one heck of a supplement. Thanks again!

Dave
91 240 original owner






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Finishing Head Gasket work FINALLY! One last question.......91 240 [200][1991]
posted by  DHartlein  on Sat Nov 11 05:29 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.