Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Drive Belts Mis-aligned and proposed solution...need feedback. 200 1993

posted by  raidman on  Wed Nov 22 16:21 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Apr 4 22:17 CST 2014
[RELATED]

I have the usual problem with (in almost EVERY 240 that I have seen); drive belts with the A/C compressor' front end tilted toward the crankshaft side of the engine. This mis alignment has caused the power steering pump to start to squeal due to the uneven pressure on the bearing.
The culprits are the mounting brackets for the A/C compressor. These are too thin to resist the inward pressure of the belts.
NOW for the proposed solution. I went to the Pick N Pull junkyard (ooops...'recycling center')and got TWO sets of brackets (total of 8 pieces). Now I am having a machine shop tack weld 2 brackets together so that the resulting bracket will be TWICE as thick as the OEM. I suspect I may not be able to use all 4 of my doubled brackets due to aligning the belt, but even if I get to install the 2 rear ones it should be an improvement to resist twisting.

Anybody done this before?
gracias,
el raidman






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Drive Belts Mis-aligned and proposed solution...need feedback. [200][1993]
posted by  raidman  on Wed Nov 22 16:21 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.