Volvo RWD 140-160 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2022 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Looking for small J-type output flange 140-160

uid 5322's pic
posted by  alschnertz on  Sat Dec 30 09:18 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:32 CST 2014
[RELATED]

I want to put a J-type overdrive into my '70.

I have a D-type in a '72 and since that is no longer used, thought it may just be easier to reuse that small flange driveshaft with the new J-type installation because it has relatively new u-joints and center bearing.

It seems that most D-types had 2-3/4" bolt centers and J-types had 3-1/8".

I think I remember discussion here though that a few J-type overdrives had a flange
with 2-3/4" centers on the bolt holes.

I guess I could put the D-type into the '70, but would rather move it into the '68 220.

So, are there any small diameter J-type flanges out there, and does anyone have one that they may want to sell?

Thanks

--
Tom - '60 544, '68 220S, '70 145S, '72 144E (formerly my driver, now parting out), '86 745T






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Looking for small J-type output flange [140-160]
posted by  alschnertz subscriber  on Sat Dec 30 09:18 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.