Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2013 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Small Flange J-Type 140-160

posted by  RepairmanJackal on  Sun Dec 31 17:24 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 10 09:52 CST 2014
[RELATED]

I went through this a few months ago. The small 3.5" diameter J-type flange exists but are relatively rare. I got mine from Don Thibaut for $50.00 plus shipping. It was *well* worth the cost. Don said that the J-sized small diameter flange was used in cars converted to/from automatic transmissions... I forget exactly.

Sadly, I had already bought both a flange and short drive shaft from a fellow in here. While that shaft was great and flange looked right, it did not fit the output shaft on my J-type. The spline-hole was too big. I'm guessing that it was really from a D-type.

Be 100% sure than the flange really does fit a J-type.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Looking for small J-type output flange [140-160]
posted by  alschnertz subscriber  on Sat Dec 30 09:18 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.