Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

strut replacement question 200

posted by  flood on  Sat Jan 27 08:49 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:07 CST 2014
[RELATED]

This might fall into the "too simple to mention" category, but I am struggling with getting everything at the top of my new strut assembly aligned perfectly enough to thread the top of the strut through without colapsing it. I can get the tippy top through, but not the threads. Even with the spring compressors, there is still a bit of pressure, so that I have to pry the spring to get
the bolt to line up--considerable force, little finesse. Any tricks? (I am wearing myself out with the number of attempts!!)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New strut replacement question [200]
posted by  flood subscriber  on Sat Jan 27 08:49 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.