Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Front oil seal replacement 200

posted by  Brickhead Dick on  Thu Feb 15 21:45 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 29 08:56 CST 2013
[RELATED]

So next week I'll be replacing my water-pump, and all belts since I'll be in that area. Figured while I'm down there might as well replace the three front oil seals.
Just looking for advice on techniques to get the new seals in place.

I hear the cam seal is the biggest pita. i also hear 3" PVC tube & a piece of soda can shaped to the diameter of the cam arm, to seat the inside seal lip.And a healthy amount of oil or grease to make it go easier. Engine oil or lithium grease?

Any help regarding this somewhat difficult task? Will the PVC/soda-can plan work? Thanks. FYI- 230F Engine.
--
'88 245,M47,Virgos 205/50/15,200K+






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front oil seal replacement [200]
posted by  Brickhead Dick  on Thu Feb 15 21:45 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.