Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2014 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

960 power seat and yes, I have read the FAQ : ) 900

Next on my list of new2me 960 projects is addressing the fore/aft movement of the drivers front seat. I've read the postings in the 700/900 FAQ and think I may have a slightly different issue. The other movement functions work fine. It's just the fore/aft one thats not working. The switch activates the motor and I can see the cables "flexing" as I engage the switch in either position and torque is applied by the motor. There is no further noise after the initial "clunk" of the motor putting torque on the cables. There is no change in the seat position on either side. This leads me to believe that I'm not having the rounded cable ends or cable pulling out from the track gear problem that is common. In other words, I don't think the cables are spinning inside the sheath. I will check again to make sure the tracks are clear but it seems unlikely that both tracks would be blocked (it seems that in the case of an obstruction, one is blocked resulting in skewed movement).

Todd
--
If it wasn't for the brickboard.com community, I wouldn't be as likely to drive a Volvo!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 power seat and yes, I have read the FAQ : ) [900]
posted by  Todd804 subscriber  on Thu Mar 8 03:01 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.