Volvo RWD 1800 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2001 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Help in identifying engine block and head 1800

posted by  tomtbone on  Tue May 15 14:29 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 16 09:34 CST 2007
[RELATED]

My Dad and I are working on a 68 1800. There was zero compression on one cylinder, so we took the head off and sure enough of the valves is stuck opem. I think we are just going to get a valve job with new valves, seats, guides.

I am new to these motors and we have run into a predicament. The engine block has 496940 1515 stamped on it. This is a B20E block correct? These is just a single carb setup on it however and this is stamped on the head: 1-418 205.

Is this a B18 head on a B20E block? Before going any further I just want to amke sure its a good idea to get a valve job done on this head.

HELP!
THanks.







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help in identifying engine block and head [1800]
posted by  tomtbone  on Tue May 15 14:29 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.