Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

what is the easiest way to test for a 'suspect' lower control arm rear bushing? 200

posted by  trichard on  Fri Jul 27 10:48 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:52 CST 2014
[RELATED]

this is one i have not had the pleasure to do but suspect it needs to be done on drivers side front control arm......the rear bushing covered by the mount cap.

i have read here about a pry bar. can someone give me more specific to do's about and where how to apply the pressure.

assuming it is bad i have saved quite a few posts form members how to replace it. there seems some difference of opinion on tightening the nut and cap bolts at the end of job??????

is my bentley's description the easiest way to do this job?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New what is the easiest way to test for a 'suspect' lower control arm rear bushing? [200]
posted by  trichard  on Fri Jul 27 10:48 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.