Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

O2 sensor removal 200

posted by  JimN696 on  Mon Aug 6 00:31 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 6 17:14 CST 2013
[RELATED]

I've been trying to remove the O2 sensor from the exhaust manifold in my '87 240. It won't budge despite treatment with penetrating oil and use of a longer ratchet wrench. The engine rocks quite a bit when I'm trying to loosen the sensor, and of course I am worried that I'll either break the engine mounts or snap off the sensor and then be required to remove the manifold. Does anyone have some helpful hints on getting this job done? Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New O2 sensor removal [200]
posted by  JimN696  on Mon Aug 6 00:31 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.