This weekend I was rebuilding the front drivers wheel hub. I pulled out the old bearings and race;s. Cleaned everything out really well and started putting everything together with the new parts. The inner race went in as regular, had to use a brass drift to get it to seat just right. Flipped it over I was putting in the outer race and it fit right in without any force. I could then move the race around in a circular fashoin and then pull it out with my fingers.

I don't fell good about leaving it in like that. Any thoughts about what I should do? Take it back for another race? I checked the old part numbers on the race with the new and they check out.......

any help would be great.

thanks