Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

hatch wiring harness, ground replacement, easy hatch support method 240 wagon 200 1986

posted by  mkoch on  Thu Jan 10 17:12 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 13 18:04 CST 2014
[RELATED]

I replaced the hatch wiring harness, both sides, on my 240 wagon, 1986.

That was not a fun job.

I'll post some photos, so others doing this might know what to expect.

The biggest challenge was supporting the hatch, while the hinge was removed. I used a ratchet-strap and a 3/4 inch thick piece of wood to support the hatch, while I removed one hinge at a time. The hatch struts stayed in place to support the hatch. The piece of wood went between the hatch, and the trailing edge of the roof.

The ratchet on the strap made it easy to position the hinge during re-installation, and made this a one-person job.









THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New hatch wiring harness, ground replacement, easy hatch support method 240 wagon [200][1986]
posted by  mkoch subscriber  on Thu Jan 10 17:12 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.