Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

separating front driveshaft from carrier 444-544 1958

uid 37415's pic
posted by  Old Kombi on  Mon Mar 10 14:28 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 30 01:42 CST 2010
[RELATED]


Hi all, has anyone had problems seperating the front drive (propeller) shaft from the carrier bearing assembly (58 444)? I have removed the screw and washer that holds the spline into the carrier bearing assy. and its flange but the spline seems to be stuck tight. I would like to get the front drive shaft out of the car for measurements and in order to replace the front U-joint on the bench.
I know that the bearing itself must be pressed off but I am just trying to remove the front DS from the carrier assembly and out the front of the car.
Is there a tool to separate the splined end of the shaft from the flange?

TIA & Cheers!
OK





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New separating front driveshaft from carrier [444-544][1958]
posted by  Old Kombi  on Mon Mar 10 14:28 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.