Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

strut nut tool 200 1992

posted by  someone claiming to be Teal 240 on  Sat May 17 07:55 CST 2008 [RELATED]

Good afternoon, folks! Well, I'm in the midst of replacing the strut bearing plates and realize that once I zapped the nut center nut off, I'll need the offset 24mm wrench to reassemble. Any ideas where to get one? I have the assembly apart and will be re-assembling next weekend and starting on the other side. Oh, one more question. The reason I'm taking them apart is the hard steering I experience and the rubber around the bearings are cracked badly. But the one I took off seems to not be binding around the bearing-any other ideas what could cause this? Your help is appreciated~ Greg






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New strut nut tool [200][1992]
posted by  someone claiming to be Teal 240  on Sat May 17 07:55 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.