Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Testing a fuel gauge 140-160

posted by  cef2lion on  Tue Jun 10 08:23 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 9 05:17 CST 2014
[RELATED]

Awhile ago I posted about a GT cluster I picked up. I pulled my 144 ORG cluster. The fuel gauge and dimmer switch on the GT cluster are not working. Checked the nuts on the gauge that make contact with circuit board. Swapped out voltage stabilizer as well. Temp gauge works. I have the fuel gauge off the cluster.

Is there a method to test the fuel gauge before I pull the glass an benzel off to take a look inside? I was wondering if the guts from my ORG gauge might fit in the fuel gauge case. The face plate is different from looking at it. Both seem to have been made by VDO.

If I get the fuel gauge going I might look at bypassing the dimmer switch. I can see part of the spring of the dimmer switch sticking out. Not sure if one could find a rheostat to replace it with that might fit through that hole.

Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Testing a fuel gauge [140-160]
posted by  cef2lion  on Tue Jun 10 08:23 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.