Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Bumper Trim replacement. Why is this so hard? 200 1988

posted by  jgreenwood on  Thu Jun 12 05:56 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Sep 11 19:10 CST 2011
[RELATED]

I think I am missing something real simple. I cannot get the front bumper center trim piece to mount. There must be an easier way. The rubber seems flexible enough. Should I loosen the bumper first, then put the trim on and hope it won't pop off when I tighten things up? Am I the only one who has this issue. I have the new clips and bought extras since I have ruined a few already. As soon as I have it on one clip and then try the next one the first pops off again. Either I am breaking them or spreading them too far to grip. Good grief! Has anyone tried epoxy? Just kidding. I need some input on this. Thanks in advance. jg






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bumper Trim replacement. Why is this so hard? [200][1988]
posted by  jgreenwood subscriber  on Thu Jun 12 05:56 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.